© Copyright LOTRONIC 2014 AD600-AD1000
Page 3
DESCRIPTION AD600
1) POWER SWITCH
Used to switch the power amplifier on or off
2) VOLUME CONTROL CHANNEL A
In stereo mode, this two control is used to adjust volume of the channel A
In bridge mode, only the A volume control adjust the level of the bridge output
3) SIG & LIMIT LED
The SIG led give you in information about level of signal.
- If the led is off, that means the level is low
- If the led flashes, that mean the level is good.
- If the led lights on, that mean the level is good but near from it max level
The LIMIT led lights on when the level is too high. in this case, decrease the level
4) VOLUME CONTROL CHANNEL B
In stereo mode, this two control is used to adjust volume of the channel B
5) GROUND SWITCH
If you listen hum noise, switch on this selector
6) MODE SWITCH
This switch is used to choose the operating mode of the power amplifier : stereo or bridge
7) INPUTS
Connect on these sockets ( Jack or XLR ) the output of your mixer ( or of the cd player )
8) OUTPUTS
Connect these sockets ( Turnlock or binding post ) to your speakers
Note : in bridge mode, connect binding post + of channel 1 and binding post + of channel B to the speaker
