15
Locate
Each Ethernet Contrio controller has a pinhole Locate pushbutton on the
faceplate that will trigger the locate function.
Pressing the Locate button using a small,
long object, such as a paperclip, will cause a
controller's front panel LEDs to flash. If the
controller is programmed and online with Audio
Architect, the corresponding controller icon will
also flash in the Audio Architect design file to
identify it.
NOTE:
Wall controllers can also be located
using Netsetter from within Audio Architect.
When the locate function is activated in Audio
Architect, the controller's LEDs will flash to
indicate that the wall controller is being located
from the software.
Boot Menu Mode
On controllers with a display, controller information such as IP address and
subnet mask can be displayed by entering Boot Menu Mode. This information
can be used for installation and troubleshooting purposes and, once
installation is complete, can be locked out from within Audio Architect to keep
network address information private.
To access and use the Boot Menu:
1.
Power off the controller.
2.
Apply power to the controller while pressing and holding the
Locate
button. Keep the
Locate
button held for about 30 seconds.
3.
Press the corresponding button to select the desired menu option.
NOTE:
The Ethernet Contrio controllers (with the exception of the EC-V
model) also have available Demo Modes which can be used to simulate
each controller's control capability. In the event you find the controller
behaving strangely after accidentally entering this mode, simply power cycle
the device to exit Demo Mode. This mode is generally reserved for sales
associates and serves no practical purpose during installation.
