Motor-driven blocking device EasyBlocker
Installation instruction
108320
2 Installation
The most advantageous installation place is as near as possible to the existing striking plate of the lock
since in this position it will have minimum effects if the door gets distorted. The blocking device can be
installed at any position. The following devices are required for the installation:
•
Borer ø 16 mm or ø 20 mm for counterpart, borer ø 8 mm for magnet
•
Test equipment for the blocking device (Item No 108322.0)
•
Assembly aid (adhesive felt) to position the counterpart (is delivered together with the blocking device)
•
Ink pad to color the assembly aid (adhesive felt)
2.1 Assembly
Attention:
When installing the blocking device on an emergency fire door, please check which
structural measures are allowed so that the door will not lose its certification!
Attention:
Installing the blocking device on escape doors is not allowed!
2.1.1 Blocking device
Mill a pocket of 20 mm width to build in the blocking device
as well as a recess to install the cuff plate in the door frame.
Provide enough space to fit a cable loop in the pocket for the
blocking device so that sufficient cable reserves are available
to extend the blocking device for service purposes.
Exactly measure the position of the blocking device or use
the included drilling template for emergency opening
instructions and make marks on the door frame in order to be
able to use mechanic emergency opening functions in case
of an error. The exact installation dimensions are shown in
figure 2-1
and
figure 2-2
. Please find further details about
emergency opening in chapter 2.1.4 as well as in chapter 3.
Optionally an angular cuff plate and a mounting housing is
available to mount the blocking device.
8320AB201en.eps
Illustration 2-1
- Assembly of the blocking device
Attention:
Clean the milled out pocket before installing the blocking device.
When screwing the fixing screws of the cuff plate please make sure that you do not damage
the cable ducts with the fixing screws.
page 4
version 6.0a / 06.04.2016
108320Err_ENG.doc