BOB’S SPACE RACERS®
3 IN 1
3 In 1 Event Trailer Operations Manual
16
DETAILED TROUBLESHOOTING AND REPAIR
Cleaning Gun Parts
It is possible after extended periods of time, or if the water you use is very
high in mineral content, that you may have to clean deposits or debris from
the gun assembly.
1. To clean the gun tip, unscrew the tip and use a water gun tip cleaner
(
BSR P/N M0006104
) (See image to the right).
2. For larger debris, unscrew the gun assembly from the top of the
Control panel. Disconnect the spring from underneath.
(See image below)
3. Remove the hose and nozzle tip from the gun.
4. Run a wire through the gun passages to remove any blockage.
5. With the tip off the gun, re-install the gun and connect the hose.
6. Play a few games to allow any debris to escape the gun body.
7. Re-install the gun tip and check for proper operation.
Target Sensors
1. Unscrew the target pan from the game.
2. Unscrew the magnetic sensor from the tank back.
3. Unplug the sensor.
4. Re-install the new sensor using the other sensor as a guide to proper
positioning. (See image to the right)
5. Check for proper alignment between the magnetic sensor and the magnet that is located on the target arm.
6. Re-install the target pan.
7. Play a couple of games to check for proper operation.
