34
LCD-V8 Portable Workstation
as shown in Figure [14]. Refer to Figure [7] to take off the back
cover. Once the back cover is removed, you can remove two
mounting screws on the side panel.
3.
Next, follow the steps in “Installing Add-on Card” to remove the
add-on card stabilizers.
Fig.[14] Mounting screws on the side and the bottom.
Fig.[14] Mounting screws on the side and the bottom.
Fig.[14] Mounting screws on the side and the bottom.
Fig.[14] Mounting screws on the side and the bottom.
Fig.[14] Mounting screws on the side and the bottom.
4.
Internal space is tight. You’ll need to pull out the drive housing to
add or remove a drive. Carefully unplug any signal and power
cables attached to drives already installed in the system. Make a
note of how they were originally connected. Especially note the
orientation of the flat ribbon cables.
5.
Face the back of the chassis and carefully pull out the entire drive
housing assembly towards you.
6.
Once you have the drive housing out of the chassis, adding or
removing internal drives is straight forward. All drives are
attached to the drive housing by four mounting screws.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
