BSH Thermador CEM304, Service Manual

Page: 22 / 80

CEM/CET/CEP Service Manual
PAGE 20
Cooktop Dimensions
INSTALLING THE COOKTOP
F
WARNING:
DISCONNECT POWER BEFORE
INSTAL-LING. BEFORE TURNING
POWER “ON”, BE SURE THAT ALL
CONTROLS ARE IN “OFF” POSITION
SECURE COOKTOP TO
COUNTERTOP
The cooktop should be secured to the countertop
using the hold-down brackets provided. Prior to
inserting cooktop into cutout, turn cooktop upside
down and attach brackets to the burner box using
the washers and screws.
Place cooktop into cutout. Insert clamping screw into
the bracket and secure cooktop to countertop.
U se a wood block to protect fragile counter top
materials.
!
G
SOLID SURFACE COUNTERTOPS
H
Always consult the countertop manufacturer
for specific instructions.
C ounter tops made from natural (i.e. granite and
marble) or SO LID SURFACE MATERIALS, such as
Sur ell™ and C or ian
®
, r equir e special cut out
preparation and installation procedures. Follow the
guidelines in preparing the cutout dimensions. Refer
to Pages 2 and 3.
Install the cooktop as follows:
1. Ro und t he cut o ut co r ner s acco r ding t o
instructions from the countertop manufacturer.
2. Apply heat reflective tape (such as Scotch
Aluminum Foil Tape # 425 or # 427) around the
cutout so that it folds over the top and side
surfaces. Be sure the tape extends beyond the
outermost flange of the cooktop. All corners
should also be covered with tape.
3. Attach brackets to the burner box using washers
and screws provided. U se a wooden block
underneath the countertop before tightening the
bracket screws.
4. Center cooktop in the cutout to insure adequate
clear ance bet ween t he bur ner box and
countertop edge. (A light pencil mark along the
center of front edge and side edge of cooktop
and counter will aid positioning of the cooktop
in the center.)
5. Trim excess aluminum tape along the frame edges.
BE C AREFUL not to scratch the countertop.
Installation above an oven, S301, SC301,
C301, CM 301 (Optional)
I , J , K ,
and
L .
T he co o kt o p can be inst alled over a single
Thermador
®
electric oven. The cooktop should be
located on the same center line as the under-the-
counter single oven. If a single oven is installed under
the cooktop, see Figure
K
for the location of the
junction boxes.
NOTE: Thermador single oven Models S301, SC301,
C301 and CM 301 installed under-the-counter with
a T hermador
®
electric cooktop over it is a U L
approved installation.
ELECTRICAL CONNECTION
1. Attach flexible conduit to the junction box.
2. Connect the cooktop lead wires to the junction
box supply wires in proper phase:
For all models, connect black (L1) to black,
red (L 2) to red, green wire to ground.
NOTE:
If the cooktop is installed and connected as
specified above, it will be completely grounded in
compliance with the N ational Electrical Code.
3. Remove ever ything from the cooktop surface and
apply Cooktop Cleaning Creme (packaged with
cooktop), as directed in Care & Use Manual, Page
10.
4. Turn on power supply.
5. Test operation.
CAUTION:
Your cooktop surface needs to be cleaned
daily. Refer to the Care and Use section
before using it for the first time.
!
https://appliancetechmanuals.com