Oven Installation
Caution:
Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned
ON accidentally.
Connecting Electricity –
Three-Wire Connection
The four-wire connection is preferred, but where local codes permit, the three
wire connection is also acceptable. See Figure 1: 3-Wire Installation.
Figure 3: 3-Wire Installation
•
Connect red wire from oven to red wire injunction box.
•
Connect black wire from oven to black wire in junction box.
•
Connect both green ground wire and white wire from oven to white (or gray)
neutral wire in junction box.
Installing Oven
For ease of installation, some oven doors may be removed to reduce the weight
of the oven by 30 lbs (14 kg) per door, before installing into the cabinet. See the
“To remove the oven door
”
section of the Installation Manual.
•
Lift or slide unit into cabinet cutout. Do not lift appliance by door handle.
•
Push straight in until oven trim is flush with cabinet wall, being careful not to
crimp flexible conduit between oven and cabinet back wall. The oven should
be straight and level, not crooked.
•
Install supplied screws through tap holes in trim. (2 screws for single ovens,
4 screws for double/combo ovens)
Testing Operation
•
Turn on power at the breaker.
•
Check power at junction box using a volt meter.
For 240 V installation, the reading between the red and black wires (line to
line) should be 220 to 240 volts.
For 208 V installation, the reading between the red and black wires (line to
line) should be 190 to 208 volts.
•
Test the oven mode.
Select the
BAKE
mode. See the Use and Care Manual for detailed
operation instructions.
•
Verify that the oven light comes on and the oven begins to preheat.
•
Test the door lock.
Set the
SELF CLEAN
mode. Confirm that the door locks when the lock icon
appears in the display.
•
If installing a double oven, test the second oven as well.
•
If any of the tests do not result as explained above, contact Thermador
service for assistance. Otherwise, the installation is complete at this time.
