6
BP2-MM PHONO PREAMPLIFIER
MUTE
POWER IN
TT GND
BP2-MM PHONO PREAMPLIFIER
LEFT
RIGHT
IN
OUT
OUT
IN
LEFT
RIGHT
1
3
4
5
7
6
2
Front and Rear Panels
1. Mute Switch
Push button switch to mute audio signal from
the BP2-MM. Press again to unmute. When in
mute, devices connected to the PS3 trigger
output are placed in standby mode.
2. Power LED
The LED lights green (optionally blue) when the
BP2-MM is operating normally and unmuted.
When in mute, the LED is red.
3. Ground Screw
Establish a secure connection to the ground
screw on your turntable when available to
reduce the possibility of hum due to ground
voltage differential between the turntable and
the phono preamplifier. This is usually done
with a cable featuring a small spade connector
on each end. The connector will accept stripped
bare wire, or with spade lug or banana plug
connector
4. Audio Input
Connect audio to your BP2-MM from your
turntable output through the left/right input
jacks.
5. DC Power Inlet
Connect the BP2-MM to your Bryston PS-3 DC
Power Supply using only the included cable to
apply power to the BP2-MM.
6. Audio Output
Connect the BP2-MM to your analog line-level
preamplifier input using the left/right output
jacks.
7. Data Plate
The data plate is located underneath the
unit and lists the model number, voltage
requirements, serial number, and date code.
Ensure that the voltage and line frequency
conform to your locality before powering the
unit on.
BP2-MM-SIL-120
Serial No: BP2-MM-00000
Date: 1530 REV: 1234
