Step 4: Set Tension On Cable
With the unit and jaws laid out
straight and with the locking
lever in the down position adjust
the side handle assembly so that
cable is straight with very little
tension on it.
See Figure 4
Next secure the Side Handle
Assembly by tighten the bolts on
the bracket.
#11 cable
#9 Locking Lever
#4 Side Handle
Figure 4
*note: When cable is hooked up
correctly the Locking lever and
jaws should look like Figures 5 &
6 when opened completely. Be
sure not to have too much
tension on the cable.
Figure 5
Figure 6
Step 6: Attaching The Lift Leverage
Stand
Slide the Lift Leverage Stand (#3)
into the intended hole on the back
of the handle. Put the M10x40
Hex Bolt (#16) through the outer
most hold on the handle and
through the hole in the Lift
Leverage Stand. Secure by
tightening bolt.
See Figure 7
Figure 7
