SRE-2010 OPERATOR 09-15-2021
8
PINCH POINT!
Make sure the areas above
and
below the folding rail are clear
before operating the
folding rail.
Keep children and pets at a safe
distance.
Failure to observe this warning
could result in injury or
damage to equipment.
The
power
folding rail is very similar to the manual folding rail
except it has a motorized actuation built into the rail hinge to
automatically raise and lower the folding section of the rail.
The power folding rail includes a mid-travel stop position.
• If you are
above
this stop, the rail should always be
folded up
.
• If you are
below
this stop the rail should be
folded down
.
Do not attempt to manually fold the power rail!
Using power from the carriage, fold or unfold the rail:
• By riding the stairlift, or
• By using the remote controls
OPERATION: Power folding rail (optional)
Riding the stairlift
:
If you are at the top of the staircase, press the armrest control switch to ride down the rail until
you contact the mid-stop, then release the switch. Look down the staircase to be sure there are no
obstructions to prevent the rail from lowering!
Press the armrest switch again, in the down direction. The folding rail will lower. The stairlift will
not move down until the rail folds down completely and touches the ground. Release the armrest
switch once the rail reaches the ground. Once the rail is folded down, press and hold the armrest
switch again until you reach the bottom of the staircase.
If you are at the bottom of the staircase, ride up until you contact the mid stop, then release the
armrest switch. Look down the staircase to be sure there are no obstructions to prevent the rail from
folding up. Press the armrest switch again, in the up direction. The rail will rise up. The stairlift
will not continue up until the folding rail is completely folded up. When the rail is in its fully up
position, release the UP armrest switch, then press it again to travel the rest of the way up the stair-
case.
Note:
You will hear a continuous beep whenever the folding rail is in motion. This is to warn
people nearby of rail operation. In addition, the yellow LED on the control panel flashes.
