GEM Setup Procedure
Page 24
GEM SETUP PROCEDURE
Based on the previous steps, the “GEM Setup” page should now be opened in your browser (see screen shot below).
Note:
The GEM exits setup mode automatically after a few minutes so you may have to re-enter if there is too much idle
time between executing settings
C
ONFIGURING
CT
S
For each channel with a connected CT, you will enter the CT Model connected to it.
1.
Click “Enter Setup Mode”
Note:
The GEM exits setup mode automatically after a few minutes so you may have to re-enter if there is too much idle
time between executing settings. All settings are saved immediately when executed.
Refer to the screen shot below
CT Settings
1.
Click “Chan CT” from the menu
2.
In the “CT Settings” box, enter the channel number
3.
Select the CT model connected to the channel
4.
Click “Save”
5.
Repeat steps 2, 3, 4 for all connected channels
Summary of Contents for DashBox
Page 35: ...Appendix B Page 34...
