BRUEL & KJAER PULSE 7788, Technical Documentation Manual

Page: 9 / 62

CHAPTER 1
Introduction
3
1.2.1 Multiple Vehicle Measurements
It may be necessary to let several vehicle exterior noise tests run in parallel. In this case,
a single Ground Station acquires the necessary acoustic and triggering reference data
for all of the vehicles and the relevant run data is merged with the Vehicle Station for each
specific vehicle. This enables several vehicles to share the track and a single system
without interfering with each other while automatically obtaining the correct
measurement results.
1.3 How to Use this Manual
This manual covers the installation and setup of PULSE Vehicle Pass-by System for
PULSE, version 19 and above.
From PULSE 19, the Vehicle Pass-by System provides two configuration solutions:
•
Ground Station only configuration, defined as
Standard
mode in the Pass-by
software
• Ground S Vehicle Station configuration, defined as
Multivehicle
mode in
the Pass-by software
The manual is designed to give you a complete item overview per configuration prior to
providing step-by-step installation instructions:
•
Chapter 2:
Provides an overview of the parts used in a Ground Station only
configuration
• Chapter 3: Provides connection and installation instructions for a Ground Station
operation alone
•
Chapter 4:
Provides an overview of the parts used in a multi-vehicle configuration,
which includes both a Ground Station and Vehicle Station
• Chapter 5: Provides connection and installation instructions for a multi-vehicle
configuration
•
Chapter 6:
Provides connection and installation instructions for a wireless LAN
system, for transfer of data from the Ground Station to the Vehicle Station in a multi-
vehicle configuration
• Chapter 7: Provides tips and tricks to solve the most common problems during
setup
•
Chapter 8:
Provides quick instructions on how to set up a configuration – with both
hardware and software