11 of 14
Start Button
While seated, press the start button. (Key switch
must be in the ON position.) Crank the engine no
longer than 20 seconds.
IMPORTANT:
The starter motor can be dam-
aged if operated
continuously
for more than 20
seconds.
Upon start-up, release the start button.
If the engine did not start, release the start button
momentarily, then try again.
IMPORTANT:
Engine will crank but will not start
if outboard is in gear, or if key switch is in OFF
position.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to
Engine Overheating
in the
Evinrude E-TEC
Operator’s Guide.
ENGINE STOPPING
Twist the throttle grip to IDLE position.
Move shift lever to NEUTRAL.
Outboard may be stopped by turning the key
switch to the OFF position, or by pressing the
STOP button until the outboard stops running.
IMPORTANT:
Be sure to turn key OFF when
outboard is not in use to avoid discharging the
battery.
SHIFTING AND SPEED CONTROL
IMPORTANT:
Carefully check the function of all
control and engine systems before leaving the
dock. DO NOT shift the outboard into FOR-
WARD or REVERSE while it is shut OFF.
Shifting
With engine running, twist the throttle grip to
IDLE position.
Move the shift lever briskly and decisively to
FORWARD or REVERSE.
1. Start button
2. NEUTRAL
005104
Water Pump Indicator
drc4952a
1
1. STOP button
005099
1. Shift lever
2. FORWARD
3. REVERSE
005100
1
3
2
1
