BRP Evinrude E-TEC, Manual

Page: 73 / 364

73
Engine Management Module (EMM)
Diagnostic Software Functions
4
Set Oil Type
The TC-W3 oil type setting is the standard setting
for all outboards. Set TC-W3 for:
•
Operation with all TC-W3 outboard oils includ-
ing
XD30, XD50, or XD100
•
Applications requiring maximum lubrication
•
Extreme applications (racing or harsh condi-
tions).
The XD100 setting provides an option to run the
outboard at a reduced oil injection rate. This set-
ting REQUIRES the use of
Evinrude XD100 out-
board lubricant and is not recommended for all
applications.
Use the XD100 setting for:
•
Conventional use (runabouts, cruisers)
•
Moderate applications.
Powerhead Break-In
Use the diagnostics software to start break-in oil-
ing after a powerhead rebuild. The break-in oiling
program runs for two hours of outboard operation,
above 2000 RPM.
Tiller/Remote Programming
This feature controls the start in gear protection
function of the neutral switch. Tiller operated mod-
els, including remote models with an installed tiller
conversion kit, MUST be set to TILLER.
Ignition Timing
Use the Ignition Timing screen to check and
adjust EMM timing. EMM timing must be synchro-
nized to crankshaft position.
1. Oil control setting 008580
1
1. Break-in oil setting 008580
1. Tiller/Remote mode setting 008580
1
1