BRP EVINRUDE E-TEC BE50DPLABA, Service Manual

Page: 44 / 422

44
ROUTINE SERVICE
LUBRICATION
Inspection
Inspect the lubricant and the magnets on the
plugs for metal chips. The presence of metal
fuzz
can indicate normal wear of the gears, bearings,
or shafts within the gearcase. Metal
chips can
indicate extensive internal damage.
Inspect the lubricant for water contamination.
Water can make the lubricant milky in appear-
ance. However, normal aeration can also cause
the same appearance.
To check for water contamination, put lubricant
into a glass container. Allow the oil to settle for a
minimum of one hour to determine if there is an
abnormal amount of water in the oil.
If water is present, refer to GEARCASE LEAK
TEST on p. 291.
Overheated lubricant will have a black color and
burned odor.
Internal gearcase inspection is recommended
when lubricant is contaminated or shows signs of
failure.
Filling
Refer to the INSPECTION AND MAINTENANCE
SCHEDULE on p. 20 for service frequency and
recommended lubricants.
Secure the gearcase in a vertical position.
Remove the lubricant level plug and the lubricant
drain/fill plug.
Use Gearcase Filler, P/N 501882, to slowly fill the
gearcase with
HPF PRO lubricant through the
drain/fill hole until it appears at the oil level hole.
IMPORTANT:
Filling the gearcase too quickly
can cause air pockets and the gearcase may not
fill completely.
Clean plug seal area and install the lubricant level
plug and
new seal, then the lubricant drain/fill plug
and new seal. Tighten plugs to a torque of 60 to
84 in. lbs. (7 to 9.5 N·m).
IMPORTANT:
The recommended gear lubri-
cants are formulated for marine applications. Do
not use automotive gear lubricants, engine oils, or
any other oil or grease.
1. Lubricant level plug
2. Lubricant drain/fill plug
27023
1
2