INSTRUCTIONS
NOTE:
Ensure to match wiring colors for connec-
tion.
11. Secure wires to handlebar using locking tie
[P8].
vsi2012-009-007_a
LH SIDE SHOWN
1. Locking tie [P8]
12. Secure wires to handlebar using locking tie
[P8].
vsi2012-009-006_a
RH SIDE SHOWN
1. Locking tie [P8]
13. Secures in place along steering column using
2 locking ties [P9].
vsi2012-009-029_a
1. Locking tie [P9]
14. On the LH side, cut part of the handlebar cover
so as to allow room for the routing of the wires
down the steering column.
vsi2012-009-031_a
1. Zone to cut off
Reinstallation
The handlebar cover installation is the reverse of
removal procedure. However pay attention to the
following:
Torque retaining screws to specification.
TIGHTENING TORQUE
U-Clamp Retaining
Screws
5 N•m ± .5 N•m
(44 lbf•
in
± 4 lbf•
in
)
Reinstall seat and console. Installation is the re-
verse of removal.
WARNING
– Make sure that handlebar turns freely in
both directions.
– Make sure that all wires/cables are clear
from contact with any moving parts or
sharp edges.
10 / 11
Instruction Sheet P/N 487 801 238