Section 03 ENGINE
Subsection 11 (GEARBOX)
F01J0ZA
vmr2006-076-003_a
To remove a bearing from a blind bore, use a blind
hole bearing puller with a hammer puller.
R610outi03A
Use an appropriate pusher to install bearing.
CAUTION: Always support crankcase properly
when installing a bearing.
Unless otherwise instructed, never use hammer
to install a bearing. Use a press only.
Always heat crankcase housing up to 100°C
(212°F) before installing bearing. Use a heat gun.
WARNING
Clean oil, outside and inside, from housing
before heating. Oil is inflammable.
Place new bearing in freezer for 10 minutes before
installation.
Push against outer race to install a bearing in its
bore.
vmr2006-076-004_a
Push against inner race to install a bearing on its
shaft.
To install countershaft needle bearing, use coun-
tershaft needle bearing installer (P/N 529 036 053).
vmr2006-066-019_a
CAUTION: Not using the appropriate pusher
will damage bearing.
vmr2006-076
105
Summary of Contents for BOMBARDIER DS250 2006
