BRP 2009 Sea-Doo GTI Series, Operator'S Manual, Page: 79 / 148

OPERATING INSTRUCTIONS
NOTICE
Never run engine longer
than 5 minutes. Drive line seal has
no cooling when watercraft is out of
water.
Close the water tap, then stop the en-
gine.
NOTICE
Always close the water
tap before stopping the engine.
NOTICE
Remove quick connect
adapter after flushing operation (if
used).
Anticorrosion Treatment
To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such as
XP-S Lube or equivalent over metallic
components in engine compartment.
Apply dielectric grease (salt water re-
sistant) on battery posts and cable con-
nectors.
NOTICE
Never leave rags or tools
in the engine compartment or in the
bilge.
Ballast System
WAKE Models
NOTE: It is not necessary to discon-
nect ballast tanks filling hose.
It is recommended to empty ballast
tanks after each use.
Always completely empty the tanks
water back to the same lake it came
from, do not transfer.
To empty ballast tanks
– Unscrew drain plugs and flush wa-
ter.
– Rinse thoroughly the tanks interior
with fresh tap water.
– When completed, close drain plugs
and tanks valve.
_______________
77