Browan TABS TBMS100-868, Reference Manual

Page: 15 / 16

Appx. 2
​
Configuration Command
(For Sensor Settings)
Port 204
Appx. 2.1 Payload
Bytes 0 1~4
Field Cmd Config
Cmd Command 1 byte
Bit [7:0] 0x00 – Set reporting interval in sec.(per unit:5min)
default value : 3600 sec
value range : 15~65535
0x02 – Set occupied interval in sec.
default value : 600 sec
value range : 0~65535
0x03 – Set
​
free detection time in min.
default value :
​
5 min
value range : 0~255
0x04 - Set trigger count in the occupied status
​
.
default value :
​
0
value range : 0~65535
0x05 - Set
​
PIR parameters.
default value : please see 4.2.1.
Config Configuration (
​
0~4 bytes )
See the table as follows:
Cmd Command Description Config Length
0x00 Get Sensor Configuration
(Only for unconfirmed downlink)
0 bytes
0x00 reporting interval in sec
*Note: little-endian format.
(Must be lesser than “keep-alive time”)
2 bytes
0x02 Occupied interval in sec
*Note: little-endian format.
(Must be lesser than “keep-alive time”)
2 bytes
0x03 Free detection time in min 1 byte
0x04 Trigger Count in the occupied status
*Note: little-endian format.
2 bytes
© 2019 Browan Communications Inc. All rights reserved.
14