•
ALWAYS ISOLATE THE APPLIANCE FROM THE POWER SUPPLY
BEFORE CARRYING OUT MAINTENANCE!
See page 5.
P 6 OF 9
•
Disconnect the heater from the power supply.
•
Remove the fire guard and bulbs. Clean with a soft dry cloth.
•
Do not use abrasive cleaners as a scratched reflector may cause the appliance to
•
overheat
•
This is normal.
MAINTENANCE:
•
Care should be taken. The fire guard can reach high temperatures during operation.
by two rocker switches located on the side of the machine.
damage the cable should be replaced.
Regular checks of the power cable should be carried out. If there are any signs of
hotspots and shorten the life of the bulb. Use gloves to handle the bulbs.
It is important that the bulbs are free of grease or finger prints as these will cause
•
The heater has two heat settings, half power and full power. These are controlled
Ensure the power indicator lamp is illuminated.
The supplier recommends that extra protection be provided by the use of a 30mA RCD.
•
Connect the appliance to the power supply. Check the dataplate for the correct supply.
machine without applying the brakes.
OPERATING THE HEATER:
Site the appliance on a firm level surface and apply the castor brakes. Do not operate the
CLEANING THE REFLECTORS:
The reflectors should be cleaned regularly.
•
Ensure the heater is cool before commencing work.
•
REPLACING THE HEATING BULBS:
Ensure the heater is cool before commencing work.
•
Disconnect the heater from the power supply.
SAFETY DEVICES:
This appliance is fitted with a tilt switch. This will prevent the machine from operating on
extreme gradient or lying down.
