13
Preparation (Camera Needle Position
Setting)
When connecting patterns by using the camera, set the
camera needle position. This operation is essential
when you use this function for the first time. It is not
necessary to perform this operation each time, but we
recommend performing it when the needle is changed.
Use the white stickers (solid) included with this Kit.
a
Prepare the needle to be used to connect
patterns.
b
Hold your finger on the screen, and then turn
on the machine.
c
Press the “Automatic Threading” button.
→
Camera needle position setting screen appears.
d
Follow the on-screen instructions to complete
the procedure.
1. Raise needle bar to its highest position.
2. Remove presser foot and replace needle
with a new embroidery needle standard
size 75/11 or 90/14.
3. Affix white sticker on needle dropping
point area.
a
White sticker
4. Press
to initiate the calibration
process. For safety please make sure area
around needle is clear prior to pressing
.
→
Setting the needle drop point begins.
Note
• Be careful not to touch the LCD screen prior to Step
below.
• This function can be performed with or without
embroidery unit attached to machine. If attached,
message screens will appear regarding movement
of embroidery unit.
Note
• The “Needle Position” button cannot be used while
setting the camera needle position. Turn the
handwheel to move the needle bar.
Note
• Use a new sticker. The camera needle position
cannot be set correctly if there is a hole in sticker or
if it is dirty. If you have no new stickers, contact your
nearest Brother dealer.
