III - 25
[ 6 ] Installing the Gears
(1) Insert the double gear 1 into the shaft of the motor holder.
(2) Insert the double gear 2 into the shaft "A" of the bottom cover, and secure their
gears with the washer.
NOTE:
Check that the double gear 1 and the double gear 2 are routed smoothly.
(3) Insert the P idle gear into the shaft "B" of the bottom cover.
(4) Insert the tape idle gear into the shaft "C" of the bottom cover.
(5) Insert the double gear 3 into the shaft "D" of the bottom cover.
(6) Insert the double gear 4 into the shaft "E" of the bottom cover, and secure their
gears with the washer.
Figure 3.1-25 Installing the Gears
Washer
Washer
Double gear 2
Double gear 1
Double gear 4
Tape idle gear
P idle gear
Double gear 3
Shaft "A"
Shaft "D"
Shaft "E"
Shaft "B"
Shaft "C"
Bottom cover
Apply grease to
the both side (back to back)
of the shaft of the motor holder.
Apply grease to the
60 degrees area of the
teeth of the double gear 1.
60
Summary of Contents for PT1090 - P-Touch - Labelmaker
Page 1: ...SERVICE MANUAL MODEL PT 1090 ...
Page 7: ...I 3 Figure 1 1 2 Display and Key Arrangement USA version EUROPE version ...
Page 74: ...A 1 Appendix 1 Main PCB Circuit Diagram NAME CODE MAIN PCB CIRCUIT DIAGRAM PT1090 LW4024001 ...
Page 75: ...A 2 Appendix 2 Key PCB Circuit Diagram NAME CODE KEY PCB CIRCUIT DIAGRAM PT1090 LW4025 001 ...
