Brother PS-53, Service Manual

Page: 19 / 77

-17-
37. Remove the total of two screws securing the left and right metal pressers and remove the upper shaft
assembly.
38. Remove the screw securing the fastening plate, then remove the feed regulator and feed regulator shaft.
39. Remove the two screws securing the BH stopper assembly, then remove the BH stopper assembly and
spring. (BH stopper assembly and spring are not used for PS53.)
40. Remove the three screws securing the selection unit, then remove the selection unit.
41. Remove the M4 hex screw.
42. Remove the screw securing the presser plate, then remove the selection dial assembly.
43. Remove the CS lock ring, then remove the torsion spring and the thread slack plate C.
44. Remove the three bottom leg rubber pads.
45. Remove the leg adjustment screws.
Disassembly Point
38. When removing the feed regulator, be careful not to lose the plastic washer (A).
These parts are not
used for PS53.
www.promelectroavtomat.ru