Chapter 2
30
Switching Between Wireless LAN Mode and USB Mode
2
Following the procedure below to switch the connection interface between wireless LAN and USB.
1 Turn on the printer, and then hold down the (Power) button for at least 3 seconds.
2 Check that the WIRELESS LAN indicator switches either from lit to blinking or from blinking to
lit, and then release the (Power) button.
NOTE
• If the printer cannot be switched to wireless LAN mode or USB mode after holding down the
button for at least 3 seconds, wait a while, and then try again.
• Default, the printer is in USB mode.
• If the printer was started up in wireless LAN mode, it will take a maximum of about 15 seconds
for wireless LAN to become functional after the printer is turned on.
• If the printer was switched to wireless LAN mode while it is starting up in USB mode, it will take
a maximum of about 15 seconds for wireless LAN to become functional.
• As with turning on the printer in wireless LAN mode, it will take a maximum of about 15 seconds
to become functional, even if the printer was started up in USB mode, then immediately
switched to wireless LAN mode.
Summary of Contents for PocketJet PJ-673
Page 75: ......
