Brother HL-3260N, User Manual

Page: 120 / 276

USER’S GUIDE
3-36
!
List of Factory settings
The following table shows the factory settings initially set before shipment.
✒ ✒ ✒ ✒
Notes
•
The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
•
The following settings cannot be restored to the factory settings with the
RESET menu in the “
FACTORY SETTINGS
” mode
: INTERFACE MODE
,
HRC SETTING
,
PAGE PROTECTION
,
SCALABLE FONT
,
LOCK PANEL
,
PAGE COUNTER
and local language for display messages.
•
The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
•
It is not possible to reset NETWORK settings from the Control panel. If
you need to reset the Network card, press the Test button on the rear of
the Network board (NC-4100h) more than 5 seconds.
M
M
M
O
O
O
D
D
D
E
E
E
M
M
M
E
E
E
N
N
N
U
U
U
F
F
F
a
a
a
c
c
c
t
t
t
o
o
o
r
r
r
y
y
y
S
S
S
e
e
e
t
t
t
t
t
t
i
i
i
n
n
n
g
g
g
PAPER PAPER PAPER PAPER SOURCE SOURCE SOURCE SOURCE
=AUTO
MP FIRST
MP FIRST MP FIRST
MP FIRST
=OFF
MP SIZE
MP SIZE MP SIZE
MP SIZE
=A4/LETTER
MANUAL FEED MANUAL FEED MANUAL FEED MANUAL FEED
=OFF
TRAY1 TRAY1 TRAY1 TRAY1
✶ ✶ ✶ ✶
SIZE SIZE SIZE SIZE
=A4/LETTER
TRAY2 TRAY2 TRAY2 TRAY2
✶ ✶ ✶ ✶
SIZE SIZE SIZE SIZE
=A4/LETTER
TRAY3 TRAY3 TRAY3 TRAY3
✶ ✶ ✶ ✶
SIZE SIZE SIZE SIZE
=A4/LETTER
TRAY4 TRAY4 TRAY4 TRAY4
✶ ✶ ✶ ✶
SIZE SIZE SIZE SIZE
=A4/LETTER
DUPLEX DUPLEX DUPLEX DUPLEX
=OFF
OUTPUT
OUTPUT OUTPUT
OUTPUT
=STANDARD
JOB OFFSET
JOB OFFSET JOB OFFSET
JOB OFFSET
=ON
QUALITY QUALITY QUALITY QUALITY RESOLUTION RESOLUTION RESOLUTION RESOLUTION
=600
HRC HRC HRC HRC
=ON
TONER SAVE TONER SAVE TONER SAVE TONER SAVE
=OFF
DENSITY
DENSITY DENSITY
DENSITY
=0
SETUP SETUP SETUP SETUP LOWER LCD LOWER LCD LOWER LCD LOWER LCD
=NONE
POWER SAVE POWER SAVE POWER SAVE POWER SAVE
=30M
AUTO CONTINUE AUTO CONTINUE AUTO CONTINUE AUTO CONTINUE
=OFF
LOCK PANEL
LOCK PANEL LOCK PANEL
LOCK PANEL
=OFF
REPRINT
REPRINT REPRINT
REPRINT
=ON
EMULATION EMULATION EMULATION EMULATION
=AUTO(EPSON)
KEEP PCL KEEP PCL KEEP PCL KEEP PCL
=OFF