Brother CS8000 Series, Service Manual

Page: 134 / 208

3 - 62
Needle-presser module Modules
24
Spring (for needle bar supporter assy.) attachment
1. Attach plate
1
and the upper unit
2
holder spring to the needle bar
supporter assy.
*Key point
• Connect the side with the short hook to the needle bar
supporter assy. plate 1 and the long side to the upper unit
holder
2
.
Start movie clip (CD-ROM version only)
S10
2
1
S10
S10
SPRING
XC2429***
24.5
25
Zigzag adjusting nut attachment
1. Apply a small amount of Epnoc Grease AP to the zigzag adjusting nut
1
.
2. Hand tighten the zigzag adjusting nut (1) on the needle bar supporter assy.
using screw
1
.
*Key point
• Set the side of the zigzag adjusting nut
1
with the greatest
eccentricity toward the top (see figure at the right).
Start movie clip (CD-ROM version only)
Apply Epnoc Grease AP to the zigzag adjusting
nut Z zigzag lever contact surface Small amount
1
Torque
0.98 - 1.37 N
−
m
1
*Rear view
1
Bolt, Socket
M4X25
Color; Black
26
Spring-Z attachment
1. Attach
1
and needle bar supporter assy.
2
spring to the upper unit
holder.
Start movie clip (CD-ROM version only)
S20
1 2
S20
S20
14.3
5
A decided hook form is the same.
SPRING-Z
XC2748***
www.promelectroavtomat.ru