Eyelet Stitching
87
3
Eyelet Stitching
Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4,
15/64 and 3/16 inch).
1
Attach monogramming foot “N”.
• For details, refer to “ Replacing the presser
foot” (page 35).
2
Select stitch
.
• For details, refer to “ Selecting stitching”
(page 58).
3
Adjust the stitch width to select the desired
eyelet size.
• For details, refer to “ Adjusting the Stitch
Width and Length” (page 51).
4
Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
5
Start sewing.
X
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
6
Use the eyelet punch to cut a hole in the
center of the eyelet.
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
●
If thin thread is used, the stitching may be
coarse. If this occurs, sew the eyelet twice
before remove the fabric, one on top of the
other.
Stitch Name
Pattern
Application
Stitch Width
[mm (inch.)]
Stitch Length
[mm (inch.)]
Presser
Foot
Auto
Manual
Auto
Manual
Eyelet stitch
Sewing eyelets, for example,
on belts
7.0
(1/4)
7.0, 6.0 or
5.0 (1/4,
15/64 or
3/16)
–
–
N
7 mm
(1/4 inch)
6 mm
(15/64 inch)
5 mm
(3/16 inch)
S2_brotherE.book Page 87 Thursday, February 13, 2003 11:03 AM
