Brother Business Smart MFC-J4510dw, Service Manual

Page: 257 / 374

4-3 Confidential
1.1 Customize destinations (Maintenance mode 74)
Customize destinations, referring to Chapter 5, Section 1.3.27 .
If "PLS UPDATE PROG" appears on the LCD, install the firmware using the procedure in
Section 1.3 below.
1.2 Set the CIS type (Maintenance mode 59)
Set the CIS type, referring to Chapter 5, Section 1.3.20 .
If "PLS UPDATE PROG" appears on the LCD, install the firmware using the procedure in
Section 1.3 below.
1.3 Install the firmware (Maintenance mode 28)
This procedure is not required unless "PLS UPDATE PROG" appears on the LCD in Section
1.1 or 1.2. If the message appears, install the firmware, referring to
Chapter 5, Section 1.3.10 .
It is also possible to install the firmware using a PC according to the following procedure.
(1) Turn the machine on and switch it to the maintenance mode.
(2) Connect the machine to your PC using a USB cable.
(3) On the PC, run "filedg32.exe."
(4) Drag and drop the firmware (e.g., lz00001_a.pjl) onto the Brother Maintenance USB
Printer driver icon in the filedg32 window.
Note: To use a firmware file, extract it beforehand by double-clicking. It is a self-extracting
file having the extension .exe.
After approx. 2 to 3 minutes, the loading operation is complete and the machine
automatically reboots and returns to standby.
(5) On the machine, display the version of the installed firmware on the LCD to check that the
firmware installation has been successfully finished, referring to Chapter 5, Section 2.2
"Displaying the Firmware Version" .
Note: If loading operation ends abnormally, turn the machine off and on. Wait for the machine
to emit a long beep and automatically enter the firmware loading mode, and then perform the
loading procedure above again with the firmware having an extension .upd.