Brother 885-X36, Operation Manual

Page: 22 / 104

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
21
4
Swing up the spool pin, and then remove
the spool cap.
1 Spool pin
2 Spool cap
5
Fully insert the spool for the upper thread
onto the spool pin.
Slide the spool onto the pin so that the spool
is horizontal and the thread unwinds to the
front at the bottom.
CAUTION
6
Slide the spool cap onto the spool pin.
Memo
●
When sewing with fine, cross-wound
thread, use the small spool cap, and leave a
small space between the cap and the spool.
1 Spool cap (small)
2 Spool (cross-wound thread)
3 Space
7
While holding the spool with your right
hand, pull the thread with your left hand,
and then pass the thread under the thread
guide A.
1 Thread guide A
8
Pass the thread under the thread guide B
from the back to the front.
Hold the thread with your right hand so that
there is no slack in the thread that is pulled
out, and then pass the thread under the thread
guide B with your left hand.
1 Thread guide B
●
If the spool is not positioned so that the
thread unwinds correctly, the thread
may become tangled around the spool
pin and the thread or needle may break.
●
If the spool cap that is used is smaller
than the spool, the thread may catch, for
example, on the notch in the spool, or
the needle may break.
a
b
a
c
b
1
a