9
HOW TO ADJUST......
Height of presser bar
Before adjustment, remove the panel assembly. Then turn the handwheel and raise the needle to its highest
position.
1. Raise the presser lever and loosen the set screw 5.95 securing the presser bar winding.
2. To adjust the height of the presser bar, raise the presser lever, and, at the point where the presser bar is horizontal,
raise or lower it until the first step is 4.8 - 5.0 mm above the needle plate. Check also to make sure that the needle
descents of the presser bar are not noticeably out of alignment with the needle descents of the needle plate.
3. After the adjustment has been completed, tighten the set screw 5.95 securely that holds the presser bar winding in
place.
Set screw 5.95
1
Presser bar
guide bracket
2
2
’
Presser foot c
Presser bar
4.8 - 5.0 mm (1st step)
Needle
descents
How to use the gauge
Gauge
Presser
bar c
Needle plate