Step 1
Starting with the front legs, align a leg
(A)
so that the
screw slots are overlapping. Fit a plastic washer
(E)
to a bolt
(C)
followed by a spring washer
(D)
and fit
it into one of the screw holes. Repeat for the
remaining two screws to fit the leg to the body of the
chair. Turn the bolt with the allen key
(F)
until it is
secure but do not tighten yet. Repeat for all four legs.
Please note that the back legs
(B)
are both the same
and are to only go at the back of the chair.
Step 2
Lift the chair off the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
B x 2
A x 2
C x 12
E x 12
D x 12
F x 1
D E
C
F
A
A
B
B
