6
7
LITHIUM-POLYMER BATTERY WARNING
This device uses a Lithium-Polymer battery . The battery must be recycled or disposed of
properly . Contact your local waste management office for information on battery recycling
or disposal .
Use only the supplied cable to recharge the battery . Improper charging may damage the
battery and the device .
Do not attempt to open the rechargeable battery or battery pack . There are no
serviceable parts inside .
Keep the battery out of reach of children . If swallowed, consult a physician immediately .
Do not dispose of battery in a fire as it may explode . The battery may also explode if
damaged .
Do not use the battery if it has been damaged, or if it is swollen, leaking, or producing an
odor . Avoid direct contact with the electrolytic material in the battery .
Turn off the product before removing the battery .
AA BATTERY PRECAUTIONS
The controller uses three AA batteries . Dispose of used batteries properly . Do not
dispose of batteries in a fire .
Do not leave the batteries where a child or pet could play with or swallow them . If the
batteries are swallowed, contact a physician immediately .
The batteries may explode if mistreated . Do not attempt to recharge or disassemble
the batteries .
Use only fresh batteries of the required size and type . Do not mix old and new
batteries, different types of batteries, or rechargeable batteries of different capacities .
BC
CHARGING THE DRONE'S BATTERY
The Build and Fly Drone includes a rechargeable Lithium-Polymer battery . Charge the
battery before first use . When the battery is becoming depleted, the front two LED lights
continuously flash slowly . Stop the flight and recharge the battery . Do not overcharge
the battery . Do not charge near combustible or flammable material, or on a conductive
surface . Do not charge when the battery is hot . Keep the battery temperature between
32° to 104° F (0°and 40° C) .
To charge the drone's battery:
1 .
Connect the battery to the provided USB Charging Cable .
2 .
Insert the Charging Cable's USB connector into a USB port
on an active device, such as a computer, USB adapter, or
power bank .
3 . The Charging Indicator in the USB end of the cable is red while charging, and turns
off when the battery is fully charged . A full charge takes approximately 60 minutes .
INSERTING THE CONTROLLER BATTERIES
The controller uses 3 AA batteries (included) which must be inserted before first use .
To insert the controller's batteries:
1 .
Unscrew and remove the battery cover on the back
of the controller .
2 .
Insert 3 AA batteries, following the polarity
indicators .
3 .
Replace the battery cover .
