110-509 BEL/EN
18
Controller Setup
Power
Press
; all characters and symbols on the LCD will momentarily light. The Circulator will begin running,
actual and set point temperatures will be displayed, and the
word “SET” will be continuously lit. The
circulating symbol will also be lit and the heating or refrigerating symbol may be lit or flashing.
Safety Set Temperature
This is a “Do Not Exceed” temperature setting for your Circulator and is the temperature at which the
heater will be turned OFF should the liquid level in the bath drop too low or the Circulator malfunctions. It
is normally set about 5° higher than the desired operating temperature. Setting the Safety Set
temperature is a four-step process.
1. Using a flat blade screwdriver, rotate the Safety Thermostat
(located beneath the cover plate) clockwise until it stops.
2. Press the
or
key; “SET” will begin flashing. Continue
pressing the
and
keys until the set point temperature is
equal to your desired Safety Set temperature. “SET” will stop
flashing approximately 10 seconds after the desired
temperature has been entered. Allow the Circulator to
stabilize at this temperature.
3. Once the bath temperature has stabilized, slowly rotate the Safety
Thermostat counter-clockwise until
you hear a soft “click;” the OVERTEMP or
LOW FLUID alarm symbol will appear on the display approximately 5-10
seconds later. At this point, the heater will also turn OFF.
4. Slowly rotate the Safety Thermostat clockwise until the alarm symbol
extinguishes (you may also feel
a soft “click”). The heater should turn back
ON. You are now ready to start normal operation.
WARNING:
The Safety Thermostat is user-adjustable from approximately 40° to 155°C. Do not force
the indicator dial beyond the stops at either end of the
dial’s range.
Heating
Refrigerating
Circulatingl
OVERTEMP / LOW FLUID Alarm
