6
l
Leaking: the cooler is designed with a built in detector. If a leak is detected,
the leaking icon will light up, the pumps, cooling, heating and dispensing
icons will be disabled until the leak is corrected. At the same time a warning
beep will sound 10 times.
START UP
1. Install drip tray below faucet.
2. Install filter system as per manufacturer’s instructions.
3. Connect the water supply to the cooler using the inlet provided. (see #9 in
diagram on page 3).
4. Connect cooler to a 120 volt electrical outlet.
5. Depress safety lock and hot faucet push button (model no.:
SOBK210MPOU) or touch safety and hot water icon (SOBK210EPOU) until
water flow is continuous and clear.
6. Power on hot switch located at the back of the cooler top left side.
l
Turn ‘ON’ the switch after installation is complete for hot water.
l
- Turn ‘OFF’ the switch if hot water is not required.
7. To set various water temperature following instructions on page 5.
8. To set the time following instructions on page 5.
CAUTION:
l
Hot tank must be filled with water before turning on hot switch. To
prevent injury children should not operate this appliance without direct
adult supervision.
l
Inlet water supply pressure should not exceed 65 PSI