REAR CARRIER PLATFORM
The rear carrier platform has a load capacity of 10kg. It mounts to the rear frame in two points, the brake
tube (fig. 29) and the dropouts (fig. 30). The rear mudguard mounts to the rack (fig 29, 31) in two positions.
Before starting it is worth removing the rear wheel from the bike in order to make it easier to fit or remove the
rack, information on this can be found on page 38.
LSDA
SPRING
WASHER
WASHER
CONCAVE WASHER
Fig. 29
CONCAVE WASHER
CARRIER PLATFORM
MUDGUARD
BRAKE
WASHER
WASHER
WASHER
WASHER
WASHER
NUT
NUT
SCREW
SCREW
DROPOUT
DROPOUT
Fig. 30
MOUNTING THE STAYS
The carrier stays mount to the dropout plates of the rear frame (fig. 27) with two M5x16 screws (A2-70
stainless DIN933) and along with a pair of washers and a Nyloc nut per side. It is important to ensure they
are fitted in the correct orientation as shown, with the right hand (driveside) screw-head being on the inside
of the dropout plate and the left hand (non-driveside) screw head in the opposite orientation on the outside.
The mounting screws should be tightened to 3Nm.
FITTING THE REAR CARRIER
Fit the parts as shown (fig. 26) ensuring that all components are assembled in the correct order and tighten
the LSDA to 10Nm.
BRAKE TUBE