Part No. COMP731-1 (LPG)
& COMP732-1 (Natural Gas)
08 March 2016 - V2
PLUMBING & GAS
Supahea
t II - Ins
truction Manual
9
6.
7.
INSTALLATION (CONT...)
OPERATING INSTRUCTIONS
NOTE:
• If there is no AGA-approved female floor socket in your premises, contact an
authorised gas fitter for installation.
• Only an
authorised person
can install an AGA-approved female floor socket in
accordance with gas fitting regulations.
• This heater is not to be installed as a fixed appliance.
Ensure you have carefully read all safety information at the beginning of this manual
before proceeding. Failing to follow the instructions in this manual exactly could result
in property damage, personal injury, or even loss of life.
1. Plug gas hose into the floor socket (see steps 7 & 8 in the “Installation” section).
2. To ignite the heater, push the “PILOT/IGN” button down and keep pressed for 10-seconds.
You will hear the clicking noise of the ignitor and the heater should then light.
3. If heater does not light, repeat step 2. Repeat no more than 3 times and
wait 30-seconds
between attempts.
4. To select the heating level, move the heat level control knob to the right for maximum
heat output or to the left for minimum heat output.
5. To turn heater off, push “OFF” button down. This will cause the “PILOT/IGN” button to lift
up. Ensure heater has turned off.
MIN HEAT SETTING
MAX HEAT SETTING
6 heating tiles glowing
3 heating tile glowing
!
WARNING:
Lighting the heater
Heater on MIN heat setting
Heater on MAX heat setting