Bromic Heating Junior Marine Installation, Instruction And  Service Manual Download Page 3

3

         

WARNINGS

“THE INSTRUCTIONS PACKAGED WITH THIS APPLIANCE CONTAIN IMPORTANT INFORMATION ABOUT 

INSTALLATION AND USE”

“DO NOT USE OR STORE FLAMMABLE MATERIALS IN THE APPLIANCE STORAGE DRAWER OR NEAR 

THIS APPLIANCE “

“DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION”

“DO NOT MODIFY THIS APPLIANCE”

‘DO NOT USE THIS APPLIANCE AS A SPACE HEATER.’

“UNSUITABILITY FOR USE IN MARINE CRAFT, CARAVANS OR MOBILE HOMES, UNLESS EACH BURNER 

IS FITTED WITH A FLAME SAFEGUARD” 

SEE TABLE 1 ABOVE

          

GENERAL WARNING

 

•  Do not store flammable materials in the cooker storage drawer.
•  Do not move this appliance during operation (ie when the burner is alight)
•  Do not use the appliance if it has a leak, or you smell gas or does not work properly
•  Always use on a flat surface
•  Always use well away from flammable materials and at least 400mm from walls or ceilings
•  Never use a flame when checking for leaks. Always use approved methods when checking for gas 

leaks

•  Important keep away form children as some parts get very hot
•  Remove transit packaging before use
•  This stove is not designed for commercial use
•  If the appliance is to be connected directly to gas cylinder, only use the AGA approved hose assembly 

supplied with the appliance.  “DO NOT USE ADAPTORS”

•  Where an AGA hose assembly is used, the maximum hose length of the hose assembly is to be 

1200mm.  “Avoid twisting or kinking the flexible hose”

•  Unsuitability for use in marine craft, caravans or mobile homes, unless each burner is fitted with a 

flame safeguard ( see table 1)

•  If the appliance is to be connected to a hose assembly, the supply connection point shall be 

accessible with the appliance installed.

•  Optional Seal Rail and Gimbal to be installed as per Appendix A

Model

Approval 

Number

Gas Type 

&

 Pressure

Injector 

L Front 

(small)

L Front Gas 

Consumption

Injector 

R Front 

(large)

R Front Gas 

Consumption

Injector 

Grill 

burner

Grill burner 

Consumption

Each 

burner 

is fitted 

with a 

flame 

safeguard

Lido 

“Junior 

Marine” 

59LT-2

AGA 

8080 G

LPG 

(propane) 

2.75 kPa

0.65 mm

5.7 Mj/hr

0.75mm

7.2 Mj/hr

0.63 mm

4.8 Mj/hr

Yes

Lido 

“Junior 

Caravan” 

59LC-2

AGA 

8080 G

LPG 

(propane) 

2.75 kPa

0.65 mm

5.7 Mj/hr

0.75mm

7.2 Mj/hr

0.63 mm

4.8 Mj/hr

Yes

TABLE 1 Specification of Models

Model

Approval 

Number

Gas Type &

 Pressure

Flame 

Safeguard

Stainless 

Fascia

Stainless 

Base

Gimble 

& Pet 

Holders

Barcode

Lido “Junior 

Marine” 59LT-2

AGA 

8080 G

LPG ( propane) 

2.75 kPa

   

Lido “Junior 

Caravan” 59LC-2

AGA 

8080 G

LPG ( propane) 

2.75 kPa

   

Lido “Junior 

Camping” 59L-2

AGA 

8080 G

LPG ( propane) 

2.75 kPa

   

Summary of Contents for Junior Marine









Reviews: