DOCID#: CD-M-BIM-7001D
U S E R M A N U A L
- 8 -
④ In setting lower limits mode, long pressing this button will enter setting upper limits mode. Press
button 9and 10 to set the upper limits value which displays in the middle of the LCD. When the
measure value more than it, alarming will occur, It will return to Absolute power measurement mode
without any operation in 10s.
⑤In setting upper limits mode, long pressing this button will enter setting wavelength mode;The
customer can press button 7 and 8 to set the wavelength,and short press button 3 to save the
wavelength.Long pressing button 3 can delete the wavelength. The number of saved wavelengths
will be displayed in the center of the screen. Or without any operation in 10s will enter Absolute
power measurement mode.
⑥
In setting wavelength mode, long pressing this button or without any operation in 10s will enter
absolute power measurement mode.
（
2
）
Relative measurement mode
In relative measurement mode, short pressing will be No response. And long press enables you to
switch between relative measurement mode and Reading memory data mode.
3)
SAVE/DELETE
（
1
）
In measuring (both Absolute measuring and relative measuring) mode, short pressing will store
the current wavelength and power value into the memorizer. The memorizer can store data up to 800
groups. In setting wavelength mode, short pressing will store the current wavelength .It is invalid to
short press this key in any other mode.
（
2
）
In the measuring (both Absolute measuring and relative measuring)mode, by long Pressing and
holding this button until a "beep" is heard, it can stored the current measurement wavelength, the
upper and lower power limits and attenuator status. Once the measuring mode is stored, the optical
power meter will keep this mode even if you restart it. But if you do not store the measuring mode,
the optical power meter will get back to its factory settings after restarting it.
（
3
）
I
n Reading memory data mode, long press it will delete the stored information. When the screen
shows “EP”, it means all data has been deleted. In setting wavelength mode, long pressing will delete
the current wavelength. It is invalid to long press this key in any other mode.
（
4
）
In setting wavelength mode, short pressing will store the current wavelength, long pressing will
delete the current wavelength.
4 )
HOLD/ATT
（
1
）
In measuring mode, short pressing will stop refresh, and show the current data. Short pressing
again will restart the data refreshing.