GSF3016E
Instruction Manual
Guide d’utilisation
10
Step 8 (Install side bar tool hanger)
a)
Turn over the left side shelf (G), then align
the holes on the end of
side bar tool hanger (H) with the holes on the left side shelf (G).
b) Insert one bolt (AA) with one spring washer (CC) and one flat
washer (DD) into each pre-drilled hole. Tighten bolts using the
screwdriver provided.
Step 9 (Side shelf assembly)
a) Loosen the four pre-installed bolts on the side of
control panel and left cart back leg, and
l
eave 1/4 of
the bolt's length extending, align the holes on the left
side shelf with the extended bolts, then push down on
the left side shelf until it clocks into place, tighten by
hand until secure.
a) Align the two holes on the left side of body assembly
with the two holes from under the left side shelf. Then
insert one bolt (BB), one lock washer (CC) and one
flat washer (DD) into each hole. Tighten by hand until
secure.
b) Repeat the procedure for the right side shelf
assembly.
c) Go back tighten all bolts using the screwdriver
provided.
Step 10 (Install side knob seat, side knob and side
burner assembly)
a) Align the holes on side knob seat (K) with the holes
on the right side shelf and side burner valve. Screw
one bolt (EE) into each pre-drilled hole.
b) Tighten the bolts using the screwdriver provided.
Insert the side knob (L) into knob shaft of valve.
c) Open the side burner lid and place the side burner
assembly (I) on the right side shelf. Connect the
venturi tube and the side valve by overlapping 0.78
inch
between venturi tube and nozzle.
d) Align the holes on the side burner assembly with the
holes on the right side shelf.
e) Insert one bolt (EE) and one flat washer (FF) into
each pre-drilled hole and screw one nut (GG) onto
each bolt by hand.
f)
Go back and tighten all the bolts using screwdriver
provided.
g) Connect the side burner ignition cable by inserting it
onto the electrode. Make certain the connection is
secure.
Connect the venturi tube
with side valve
Insert the ignition cable
onto electrode
