5
Refer to the following guide for cleaning certain staining agents (Applies to the Permablok3® vinyl, as per the vinyl
manufacturer’s recommendations) The frame and components of the chair can be cleaned using the same procedure
as the vinyl.
The steps below are also located in the Cleaning Guide found on the back of the BRODA chair.
Staining Agent
Cleaning Procedure
Eye Shadow / Mascara
Step 1
Grease / Suntan Lotion / Chocolate
Step 1
Blood / Bodily Fluids
Step 2
Red Lipstick
Step 2
Oil Base Paint / Tar / Asphalt
Step 3
Other Tough Stains
Step 4 or 5*
Step 1:
Remove excess spill with a damp cloth. Clean with a 1:1 mix of Ivory® liquid and water. Rinse with clean
water and dry.
Step 2:
Use a straight application of concentrated cleaners such as Formula 409® or Fantastik® Spray Cleaner.
Then wipe with a clean cloth. If using a hospital grade cleaner, follow the diluting instructions on the label.
Step 3:
Use a 1:1 mix of ammonia and water or a 1:4 mix of bleach and water. Rinse with clean water and dry.
Step 4:
Use a straight application of naphtha (lighter fluid). Rinse thoroughly with clean water and pat surface dry.
Step 5:
Use a 1:1 mix of isopropyl alcohol and water. If the stain persists, use straight alcohol. Rinse thoroughly
with clean water and pat dry. If the stain remains, use a 1:1 mix of acetone and water. Rinse with clean water and pat
surface dry.
*Note:
for cleaning that requires steps 4 or 5 – Use a soft cotton cloth saturated with the cleaning material and rub
the stain in circles 10 times. Pat dry with another soft cotton cloth, and check results.
Thoroughly clean all removable parts and padding, as well as the frame and components.
BRODA chairs should not be cleaned with petroleum based cleaners. Any petroleum based products that come in
contact with any vinyl surface should be removed as quickly as possible. Petroleum based products make vinyl
brittle and will damage the seating surface and cushions. Metal parts and cushions should be wiped completely dry
after cleaning. Do not launder vinyl padding.
Do not allow the chair to air dry. Leaving the chair to air dry and not ensuring the entire chair is completely dry may
cause the frame and components to rust. Solvents such as those found in spray lubricants should not be used on
BRODA chairs as they can damage moving parts.
Frequency and method of cleaning the chairs should be determined by facility infection control protocols. If visibly
soiled, thoroughly clean the chair immediately as per the cleaning instructions in this manual.
The cleaning instructions in this manual are guidelines only. Results may vary under actual conditions. The
information does not relieve the user of proper and safe use of the product and all cleaning agents and consideration
for the overall cleaning maintenance of the chair. Cleaning and care instructions must be followed in conjunction
with facility infection control protocols.
BRODA will not accept warranty or liability claims on chairs that have not been cleaned according to the
instructions or cared for in proper regard for the child, caregiver and third party safety and hygiene.. The use of
certain agents may be harmful to the surface appearance and lifespan of the vinyl. BRODA assumes no
responsibility resulting from the use of such cleaning agents to the vinyl.
Touch up paint is available for the powder coated frame. Please call BRODA’s Customer Service Department if
touch up paint is required. Do not leave BRODA chairs outdoors as the frame is not UV protected. Leaving the
chairs outdoors could cause the paint to peel.
