Brocade Communications Systems VA-40FC, Hardware Reference Manual

Page: 11 / 60

Brocade VA-40FC Hardware Reference Manual xi
53-1001540-04
Getting technical help
Contact your switch support supplier for hardware, firmware, and software support, including
product repairs and part ordering. To expedite your call, have the following information available:
1. General Information
•
Technical Support contract number, if applicable
•
Switch model
•
Switch operating system version
•
Error numbers and messages received
•
supportSave command output
•
Detailed description of the problem, including the switch or fabric behavior immediately
following the problem, and specific questions
•
Description of any troubleshooting steps already performed and the results
•
Serial console and Telnet session logs
•
syslog message logs
2. Switch Serial Number
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below.:
The serial number label is located as follows:
•
Brocade 300, 4100, 4900, 5100, 5300, 7500, 7500E, 7800, 8000, VA-40FC, and
Brocade Encryption Switch—On the switch ID pull-out tab located inside the chassis on the
port side on the left
•
Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch
•
Brocade 7600—On the bottom of the chassis
•
Brocade 48000—Inside the chassis next to the power supply bays
•
Brocade DCX—On the bottom right on the port side of the chassis
•
Brocade DCX-4S—On the bottom right on the port side of the chassis, directly above the
cable management comb
3. World Wide Name (WWN)
Use the wwn command to display the switch WWN.
If you cannot use the wwn command because the switch is inoperable, you can get the WWN
from the same place as the serial number, except for the Brocade DCX. For the Brocade DCX,
access the numbers on the WWN cards by removing the Brocade logo plate at the top of the
non-port side of the chassis.
*FT00X0054E9*
FT00X0054E9