Brocade Communications Systems ICX 6650 series, Hardware Installation Manual

Page: 33 / 83

FIGURE 17 Optional 4-post rack mount kit, side attachment
4. Position the switch in the cabinet, providing temporary support under the switch until the rail kit is secured to the cabinet.
5. Attach the front right bracket to the rail rack using two 10-32 x 5/8 in. screws and the appropriate round-hole or square-hole
retainer nuts.
6. Repeat step 5 to attach the left front bracket to the left front rack rail and tighten all 10-32 x 5/8 in. screws to a torque of 25 in-
lb (29 cm-kg).
7. Attach the rear right bracket to the rail rack using two 10-32 x 5/8 in. screws and the appropriate round-hole or square-hole
retainer nuts.
8. Repeat step 7 to attach the rear left bracket to the rail rack and tighten all 10-32 x 5/8 in. screws to a torque of 25 in-lb (29
cm-kg).
Proceed to
Attaching a PC or terminal on page 33.
Attaching a PC or terminal
To assign an IP address, you must have access to the command line interface (CLI). The CLI is a text-based interface that can be
accessed through a direct serial connection to the device and through Telnet connections. The CLI is described in detail in the
FastIron
Ethernet Switch Administration Guide .
Access the CLI by connecting to the console port. After you assign an IP address, you can access the system through Telnet, the Web
management interface, or Brocade Network Advisor.
Attaching a PC or terminal
Brocade ICX 6650 Hardware Installation Guide
Part Number: 53-1003621-04 33