Brocade Communications Systems DCX Backbone, Hardware Installation Manual

Page: 37 / 167

5. Attach the clip nuts (for rails with round holes) or retainer nuts (for rails with square holes) to the vertical rails on the exhaust aisle
side of the rack (see the previous figure). These clip nuts are used for securing the port side of the device to the rack rails using
10-32 x 5/8 inch screws. Use three clips on each rail. Place the clips in optimum locations for securing the device to the rails.
NOTE
Do not align the clip or retainer nuts with the top or bottom holes of the mounting bracket because the screw heads will
interfere with the door.
Installing the device in the rack
Use the following procedure to install the device in the rack.
DANGER
Use safe lifting practices when moving the product.
1. Ensure that the door, if installed, is removed from the port side of the device. For instructions, refer to instructions for removing
and replacing the device door in the device installation guide.
2. Use a lift to raise the device to the level of the shelf brackets.
3. Move the lift as close as possible to the rack, with the air-intake side of the device facing the front of the rack (see the following
figure).
4. If applicable, lock the wheels of the lift.
Installing the 14U Rack Mount Kit for Four-Post Racks (XBR-DCX-0120 and XBR-DCX-0152)
Brocade DCX Backbone Hardware Installation Guide
53-1000685-24 37