Brocade Communications Systems Brocade TurboIron 24 Series, Hardware Installation Manual, Page: 43 / 78

Brocade TurboIron 24X Series Hardware Installation Guide 43
Part Number: 53-1003053-03
Maintaining the TurboIron 24X
Hardware
This chapter contains the following sections:
•
Hardware maintenance schedule . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
•
Replacing a fiber optic module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
•
Replacing a power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
•
Replacing the fan tray. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
Hardware maintenance schedule
This chapter provides instructions for maintaining the TurboIron 24X hardware.
The procedures in this manual are for qualified service personnel.
The TurboIron 24X switch hardware components require minimal maintenance. TurboIron recommends that you clean the fiber- optic
connectors on fiber-optic ports and the connected fiber cable each time you disconnect the cable.
You can replace the following hardware components as needed:
•
Fiber optic modules (SFP+ transceivers)
•
Power supplies
•
Fan tray
Replacing a fiber optic module
You can remove an SFP or SFP+ from a port and replace it with a new one while the TurboIron 24X is powered on and running.
This section provides information about the following tasks:
•
“Removing a fiber optic module”
•
“Installing a new fiber optic module”
•
“Cabling a fiber optic module”
Removing a fiber optic module
You can remove a fiber SFP+ (also called a Small Form-factor Pluggable Plus) or an SFP from a port while the TurboIron 24X is powered
on and running.
Before removing a fiber optic module, have the following on hand: