model QB130SS
Page 5
inStall tHe Hood
18 Run
House Power cable
between service panel
and hood location. Attach power cable to hood using
appropriate clamp.
19
Hang hood from (4) mounting screws driven part-way into
cabinet locations (shown in illustrations under “PREPARE
HOOD LOCATION”). Mounting screws are included in
parts bag. Slide hood back towards wall until mounting
screw heads are engaged in narrow end of keyhole slots
in top of hood. Tighten screws securely.
20
ducted inStallation onlY:
Connect ductwork to hood and use duct tape to make
joints secure and air-tight.
Make sure the damper / duct
connector enters the ductwork and that the damper
opens and closes freely.
HOUSE
POWER CABLE
warning
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
16 Remove
electrical wiring Box cover
from inside of hood.
17
Remove appropriate
electrical Power cable Knockout
from top or back of hood.
ELECTRICAL
POWER
CABLE
KNOCKOUT
15
ducted inStallation onlY:
Attach
3¼” x 10” damper/duct connector
over the
knockout opening.
3¼” X 10” DAMPER / DUCT
CONNECTOR
note
To accomodate off-center ductwork, the 3¼” x 10”
damper/duct connector can be installed up to 3/8” on
either side of the hood center.
14
ducted inStallation onlY:
Remove 3¼” x 10 vertical or 3¼” x 10” horizontal
knockout plate
as appropriate for your ducting method.
3¼” X 10”
HORIzONTAL
KNOCKOUT
PLATE
3¼” X 10”
VERTICAL
KNOCKOUT
PLATE
ELECTRICAL WIRING
BOX COVER
