End Product Labeling
This transmitter module is authorized only for use in device where antenna
may be installed such that 20 cm may be maintained between antenna and
users (for example access points, routers, wireless ADSL and similar
equipment). The final end product must be labeled in a area with the following:
“Contains TX FCC ID: GI4L-MS6868H”.
Manual Information for End Users
The end user must not have manual instructions to remove or install device.
The user manual for end users must include the following information in a
prominent location: “IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located operating in conjunction with any other antenna or
transmitter. as a result of e-mail transmission.”
Important Safety Precautions
Always read and follow these basic safety precautions carefully when handling
any piece of electronic component.
1. Keep this User Guide for future reference.
2. Keep this equipment away from humidity.
3. Lay this equipment on a reliable flat surface before setting it up.
4. The openings on the enclosure are for air convection hence protects the
equipment from overheating.
5. All cautions and warnings on the equipment should be noted.
6. Never pour any liquid into the opening that could damage or cause electrical
shock.
7. If any of the following situations arises, get the equipment checked by a
service personnel:
Liquid has penetrated into the equipment
The equipment has been exposed to moisture
The equipment has not work well or you can not get it work
according to User Manual
The equipment has dropped and damaged
If the equipment has obvious sign of breakage
8. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT
UNCONDITIONED, STORAGE TEMPERATURE ABOVE 60
°
C OR
BELOW -20
°
C, IT MAY DAMAGE THE EQUIPMENT.
