53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
NOTE
Screws, clip nuts, and retainer nuts to secure the device to the rack are provided in the device hardware
accessory kit.
Figure 15: Device and 27-31 in. (68.58 to 78.74 cm) Kit Installed in Rack
1. Screw locations for 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32 x .63 in.(1.60
cm) Phillips screw with square cone washer for racks that have rails with round holes.
NOTE
For rails with round holes, use the clip nuts on the rails for securing the 10-32 screws. For rails with square
holes, use the retainer nuts.
6. Reinstall the device door. See the procedures for removing and replacing the device door in this guide.
Installing the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks
Use the following instructions to install the device in a rack using the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks
(XBR-DCX4S-0126 and XBR-X64-0126). Observe the following when mounting this device:
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation
Guide.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are
installing into the rack.
Time and Items Required
Allow approximately one hour to unpack and install the chassis in a rack.
The following tools are required when installing the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-
DCX4S-0126 and XBR-X64-0126):
53-1004106-15
39
Summary of Contents for Brocade X6-4
Page 208: ......
