Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
Configure
8
Led Mode
Description:
A device can be configured to use one LED to indicate speed and activity or three LEDs.
Use a devices data sheet to verify the LED modes supported by a devices and for
exceptions to the LED modes described below.
Mac Mode (0)
The LEDs are controlled by the value in the Mac LED Control Register.
Phy Mode1 (1)
Dual Link LED configuration. Two LEDs are used to indicate 10/100
Mbps.
Phy Mode2 (2)
Link/Speed LED configuration. One LED is used to indicate link status
of all 10/100 Mbps.
SharedTraffic (3) Shared Traffic/Link LED Mode. The Link LED performs dual role: Solid
Green, when Link up. Blink when there is an activity.
Configure
9
VPD Data
Description:
VPD Product Name and Read Data.
Part Number (1)
VPD Part Number
Engineering Change (2)
VPD Engineering Change
Serial Number (3)
VPD Serial Number
Manufacturing ID (4)
VPD Manufacturing ID
Read only VPD Data (5)
VPD Read only V0 Data
Product Name (6)
VPD Product Name
A
Configure
Super Airplane Mode
Description:
Super Airplane mode
Disable
Disable Super Airplane Mode
Enable
Enable Super Airplane Mode
Configure
B
MBA Configuration
Description:
MBA Configuration
VLan Enable (1)
Enabled / Disabled
VLan ID (2)
VLan ID
MBA Hide Banner (3)
Enabled / Disabled
Ctrl-B / Ctrl-S
MBA Hot Key (4)
PXE / RPL / BOOTP / ISCSI
MBA Protocol (5)
MBA Config Timeout (6)
MBA Config Timeout value
C
MBA Bootstrap (7)
Auto / BBS / INT18 / INT19
MBA Link Speed (8)
Auto /10HD / 10FD / 100HD / 100FD
Configure
Design Type
Description:
Select NIC or LOM based Ethernet controller.
NIC(1)
Option selected for a plug in network interface card.
LOM(0)
Option selected for a LAN on motherboard.
D
Configure
L1 PLL Powerdown Disable
Description:
Disable / Enable L1 PLL Powerdown
page 58
Broadcom Confidential and Proprietary
