e-mail:
voice:
360.854.9559
fax:
866.783.1742
4
DTD-16 Installation and Operation Manual
PROGRAMMING
PROGRAMMING
To program the DTD-16, you must connect a PC running a terminal program such
as HyperTerminal, etc. Set the terminal program to 9600,8,N,1, flow control to
NONE. Character Echo must be turned ON. There are two methods of entering pro-
gram mode. Either press the recessed “PGM” button or send an ASCII “P” to the
serial port. Once program mode is entered, the “PGM” LED will begin to flash and
the current data will be displayed.
01-0-A-1/
02-0-A-2/
03-0-A-3/
…..
16-0-A-D/
SELECT 01-16 & ENTER 0=MOM, 1=LATCH, 2=XLATCH,
DELAY A-O (0-15 SEC), MOM OR ON CODE / OFF CODE:
(The factory default has single digits corresponding to each output, 1 for 1, 2 for 2,
etc. Output 10 is DTMF zero, 11 = *, 12 = #, 13 = A, 14 = B, 15 = C, 16 = D. These
default values may be reloaded at any time by removing power from the DTD-16,
holding down the PGM button and plugging in the power. Release the PGM button
after a few seconds. The PGM LED will blink once after the defaults are loaded.)
Default time delay before activation is “A” or 0 seconds
To program, enter the output number 01 through 16. The “-“ (dash) will be displayed
after the numbers are entered along with a new line. Next, enter a single command digit:
“0” for momentary, “1” for Latch or “2” for Exclusive Latch. The “-“ (dash) will be dis-
played after the command digit and a new line will be displayed. Then enter a time delay
value A-O where A=0 Seconds, B=1 Second, C=2 Seconds, etc., through the letter O=15
seconds. This is the time that will elapse after a command is received and the output is
activated. Now enter the code you want to use to operate the selected output:
Momentary
If you have selected the momentary function for this output channel, you can enter two
codes up to 5 digits for the first code and 6 digits for the second code that can be used to
activate that output. If your code is shorter than 5 digits enter a “/” at the end of the first
data string. This will cause a new line to be displayed. Enter the second code you want
to momentarily trigger. If the string is less than 6 digits press the “Enter” key. The codes
for that output will now be saved and you can go on to programming another output.
Example
To program output 1 for momentary for code 123 and 321 with a time delay of 4
seconds before activation:
01-
0
E
123/
321(CR)
Latch
WEBSITE:
Visit our web site for
product updates and
additional information
