Broadcast Tools DSD-2 Installation And Operation Manual Download Page 2

ee--m

maaiill::  

[email protected]   

vvooiiccee::  

360.854.9559   

ffaaxx::  

360.854.9479 

2

DSD-2 Installation and Operation Manual

INTRODUCTION

INTRODUCTION

Thank you for your purchase of the 

Broadcast Tools® Dual Sub-Audible Tone

Detector,

which we will refer to throughout the manual as the 

DSD-2

. We’re con-

fident this product will give you many years of dependable service.

This manual

is intended to give you all the information needed to install and operate the product.

SAFETY INFORMATION

Only qualified personnel should install Broadcast Tools® products.  Incorrect or
inappropriate use and/or installation could result in a hazardous condition.

Broadcast Tools, Inc., is unable to support NON-Broadcast Tools software, hardware or
NON-Broadcast Tools computer/hardware/software problems.  If you experience these
problems, please research your hardware/software instruction manuals or contact the man-
ufacturers technical support department.

WHO TO CONTACT FOR HELP

If you have any questions regarding your product or you need assistance, please con-
tact your distributor from whom you purchased this equipment.

If you would like more information about Broadcast Tools® products, you may
reach us at:

Broadcast Tools, Inc.

131 State Street
Sedro-Woolley, WA 98284-1540 USA
Voice: 360 . 854 . 9559
Fax:

360 . 854 . 9479

Internet Home Page: www.broadcasttools.com
E-mail:

[email protected]

THANK YOU FOR CHOOSING 

BROADCAST TOOLS® BRAND PRODUCTS!

CAUTION!

Broadcast Tools®

Products, as with any
electronic device, can
fail without warning.
Do not use this product
in applications where a
life threatening condition
could result due to failure.

NOTE:

This manual should be
read thoroughly before
installation and operation.

WEBSITE:

Visit our web site for
product updates and
additional information.

Summary of Contents for DSD-2









Reviews: